Alpakka PCB (Fully soldered)
Printed Circuit Board according to Alpakka reference design. All components soldered.
Soldered:
(1x) Raspberry Pi Pico.
(1x) Thumbstick.
(1x) Rotary encoder.
(1x) 8-directional switch.
(4x) Trigger switches.
(13x) Face buttons.
(2x) IMU chips (gyros).
(2x) IO expander chips.
(4x) LEDs (white).
(1x) JST dev kit connector.
(1x) Blade connector (for the touch surface).
All required resistors and capacitors.
Disclaimers:
DIY projects involve inherent risks. It is essential to exercise caution, employ appropriate safety measures, and seek professional advice or assistance when necessary. The seller strongly recommends conducting thorough research and acquiring the necessary skills and knowledge before attempting any DIY projects. You acknowledge that you are solely responsible for the proper and safe usage of these items in any DIY projects you undertake. The seller cannot be held accountable for any injuries, damages, or losses incurred as a result of your actions.
The buyer agrees to comply with all applicable laws, regulations, and safety standards when using the articles or products purchased. It is your responsibility to ensure that your DIY projects adhere to all relevant legal requirements and building codes.
Do not use this article with external batteries.
Do not leave this article unattended while connected to a power source.
This article is not meant to be modified nor assembled by minors. And must not be used without adult supervision.
Version and characteristics may differ from shown image.